🎲 Design Concept :

Here is the new version of the dice tower book, ideal for role-playing gamers (or dice gamers in general).

This new version is sturdier with three anchor points at the hinges and a redesigned lid.

Thanks to this book, you can carry everything you need to run a role-playing game session wherever and whenever you want.

You can store a set of dice, a pencil, and a notepad inside.

Once opened, it serves as a dice tower: you roll the dice into the groove in the lid, and they land in the bottom of the book. This way, they don't roll around, and you won't have to search for them under the table.

This model is inspired by heroic fantasy adventures and depicts a dragon.

This model was created without AI tools and has already been printed several times on different printers.

📐 Print Settings :

Layer height : 0.16mm,

Infill : 10%,

Support : yes - tree

Brim : no

WARNING : This model requires the use of a CFS.

⚙️ Assembly :

Additional supplies needed :

- 4 round 10mm magnets

- 1 10cm pencil

- 1 set of dice

- Glue

Assembly steps :

- Insert the magnets into the groove section

- Glue the groove to the top cover section

- Glue the blank pages to the bottom section

- Glue the magnets into the blank pages section (pay attention to the orientation of the magnets relative to those previously glued to the top section)

- Place the cover on the bottom section, aligning the hinges. Insert a piece of filament along the hinges to secure everything.

Dice tower Book DRAGOON – Tour à dés livre

Hi Dragoon book - 0.16mm layer, 2 walls, 10% infill