I needed some specialized cable clips for Ender 3 v3 CoreXZ for the top mounted led lights and the filament runout sensor cables.

Hook the clips from the backside and push down over the cable and the printer arm, it will clip into its place. Check the photos for the reference.

To remove the clips; just push down from the front side and reverse the mounting procedure.

You can use the print for both sides of the printer.

No support, no brim, no nothing.. just print it as is and Ender 3 v3 prints its under 5 minutes without any elephant foot problems.

0.2mm layer height, I printed it with PLA+, but PETG might be better.

WARNING! The side mount clips is very close to the nozzle head mechanism.

At normal operation there is enough clearence between the header and the clips

BUT if you move the header manually on X axis, the nozzle head might move too close to the sides and crash the Clips while moving on the Z axis.

Be warned and be careful if you like to move the header manually.

It perfectly works for me, use it at your own risk (:

Ender 3 v3 CoreXZ Cable Clips - Top & Side