由于找不到适合Ender-3 V3 plus的挤出机线缆拖链，我设计了这个挤出机线缆防下垂支架，相较于拖链来说更加简单有效。

打印时要注意摆放方向，使卡扣的C形截面水平放置，否则安装时易断裂。建议使用提供的3MF设置打印，耗材根据自己的情况调整。

安装方法：将支架扣在右侧后斜撑的线缆扣上方位置，适当调节高度，使线缆可在挤出机左右移动时在支架杆上自由滑动，不会卡主即可。长时间使用可能会松动下滑，在支架和线缆扣之间添加高度调节卡扣即可保持支撑高度，卡扣长度可在切片前根据实际高度需求缩放调节。

线缆再也不会被细高件勾住了！

Ender-3 V3 Plus Extruder Cable Anti-Sag Bracket: A simple yet effective alternative to cable chains.

Unable to find a suitable cable chain solution for the Ender-3 V3 Plus, I designed this anti-sag bracket. It provides a simpler and more reliable solution for cable management.

Printing Instructions:

Orient the model so the C-shaped clamp section lies flat on the build plate. Printing it vertically may cause the clasp to break during installation.

For best results, use the provided 3MF file settings. You may adjust the filament type based on your preference.

Installation Guide:

Snap the bracket onto the right rear vertical strut, just above the existing cable clip.

Adjust the height so the extruder cables can slide freely along the bracket's rod during left-right movement without snagging.

If the bracket slips down over time, insert the included height-adjusting spacer between the bracket and the original cable clip to maintain position. Scale the spacer in your slicer to achieve the precise height needed.

Say goodbye to cables snagging on tall prints!

Ender-3 V3 plus 挤出机线缆防下垂支架 Extruder Cable Anti-Sag Bracket

0.2mm layer, 3 walls, 25% infill

0.2mm layer, 2 walls, 15% infill