Designed for use in a costume ball or masquerade, these masks are small, lightweight, and packed with great surface textures that show up even at 0.20mm layer height!

Printed using Bambulab Glow in the Dark PLA.

Please be aware that, due to the required printing size to make a wearable mask, this model is not suitable for an A1 mini.

Wearing the mask

Holes for threading straps are found on the sides, below the ears.

The thicker the cord/strap, the better support you'll have keeping the mask on.

The mask was sculpted over a standard styrofoam mannequin head model (Find it here) which makes the mask suitable for most adults to wear, but they are small as they are intended for balls/parties and not for cosplay (though scaling them up should work).

Print Set-up

Supports are required to print the mask; without them, the mask will not print well, if at all.

Turn supports ON.

Set the type to “Tree - Auto”.
Set the style to “Organic”.

The threshold angle should be unchanged (the default is 30).

Tick the “on build plate only” box.

Using a brim is optional, but is highly recommended, as the mask profile is narrow it is at risk of coming off the hotbed without the brim.

I have provided painted examples in the file, but they are NOT optimised for printing! They are just there as examples. As always, I recommend printing them in flat colours, spray-painting them with a primer, then painting them by hand.

NOTE: The 3mf provided was made in Bambu Studio and may not open in Creality Slicer. Please use the raw STL's if the 3mf doesn't open.

This file covers personal, non-commercial use; do not share or redistribute without attribution. Do not sell the files or prints of the files. Remixing is allowed but again providing attribution is required. Do not remove the creator stamp.

If you want to sell prints of this model, please visit my Patreon to learn how to obtain a Commercial License: https://www.patreon.com/thomastedwards

Feline and Canine Party Masks

0.2mm layer, 2 walls, 15% infill