Geometric Tealight Holder Set (3 Heights)

A set of three modern, geometric tealight holders with a minimalist design. Each model features the same base geometry but a different height (22.5 mm, 29.5 mm, and 36.5 mm), creating a dynamic and stylish composition for any interior.

⚠️ MATERIAL WARNING: DO NOT USE PLA ⚠️

Metal tealight cups can get very hot (over 50-60°C). PLA will deform or melt. For safety and durability, please use heat-resistant filaments like PETG, ASA, or ABS.

Print Settings & Technical Details:

Supports: Mostly support-free. The shortest and medium models print perfectly without supports. The tallest model has a steeper overhang and might require minimal paint-on supports at the lowest point of the curve, depending on your printer's cooling.

Layer Height: 0.20 mm – 0.28 mm (0.16 mm recommended for smoother facets and chamfers).

Infill: 10–15% (Gyroid, Cubic, or Grid). The infill also acts as an air insulator.

Orientation: Print upright, flat on the bottom face.

Scaling: Do not scale the models, otherwise standard tealights will not fit inside the holes.

Aesthetics: Matte or stone-fill filaments (non-PLA) are highly recommended to highlight the geometric shapes.

Geometric Tealight Holder Set (3 Heights)

0.2mm layer, 2 walls, 15% infill