Summary

This is a Vacuum Hose Boom to help support your Vacuum Hose while using your Suckit Dust Boot. If you plan on using a dedicated Vacuum Hose you can zip tie the Vacuum Hose to the Boom. If you often remove the Vacuum Hose to use elsewhere you can use the Clips. For maximum strength and durability, I recommend using ABS with 4 perimeters with a 20% infill. No rafts or supports are required. Position parts with the flats on the heat bed.

This product can be purchased at https://www.suckitdustboot.com

Tube Cut Length: 10" for Bottom and Mid-section and 7" for the Top Tube.

The Tubing used is 1" O/D Aluminum and can be purchased at :

Home Depot: https://www.homedepot.ca/en/home/p.1x3-round-aluminum-tubing.1000163849.html

Mcmaster Carr: https://www.mcmaster.com/4568t17

Print Settings

Printer brand:

Prusa

Printer:

i3 MK2.5

Rafts:

Supports:

Resolution:

0.20mm

Infill:

Filament brand:

Generic ABS

Filament color:

Black

Filament material:

ABS

Notes:

Use 4 perimeters for maximum strength and durability.

License

CC BY-NC-SA

Suckit Vacuum Hose Boom

by Makerrmark is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.

Hose Boom Arm 1.875" Vacuum Clip

0.2mm layer, 2 walls, 15% infill