Door Seal
If you are printing this, you might also like this door seal for the K1 Max
- Factory hinges: https://www.crealitycloud.com/model-detail/k1-max-door-seal-standard-hinges
- 270-degree hinges: https://www.crealitycloud.com/model-detail/k1-max-printer-door-seal-270-degrees-hinges

Design Concept

The K1 Max door panel seal is designed to provide an efficient solution for enhancing the sealing capabilities of 3D printer doors. It aims to prevent dust and debris from entering the build area, ensuring improved print quality.

Uses

The seal is used in 3D printing setups with the K1 Max and has been confirmed to fit the K1 and K1C printers. It is a practical accessory for maintaining optimal conditions in the printer's interior.

Printing Suggestions

I've used PLA and have no issues, however, you might find printing in a high-temperature resistant filament like PETG or ABS to ensure durability when the enclosure is heated.

Installation Instructions:
- Make sure the clip that slides over the frame seal is not too rough.

- Unclip the front panel by sliding it upward.

- Insert the new panel by resting it on the bottom frame, then push it sideways into position (not sideways then down).

- Ensure the clip on the new panel slots into the notch—see picture 5 for reference.

- Reattach the front panel by clipping it back into place.

Door SealIf you are printing this, you might also like this door seal for the K1 Max - Factory hinges: https://www.crealitycloud.com/model-detail/k1-max-door-seal-standard-hinges- 270-degree hinges: https://www.crealitycloud.com/model-detail/k1-max-printer-door-seal-270-degrees-hingesDesign Concept

Uses

Printing Suggestions

K1 , K1C and K1 Max door panel seal

0.16mm layer, 2 walls, 15% infill

0.2mm layer, 4 walls, 15% infill

0.2mm layer, 4 walls, 15% infill, PETG