Wingspan : 760mm

Takeoff weight : ~720g

Battery : 3S 800 - 1800mAh

Motor : 2830-1100kv

Propeller : 10x6

Flight time : > 10min (1800mAh), 8min (1000mAh)

COG : 70mm from front of wing part (exactly on main longeron)

Content:

/fuselage - Fuselage parts

/wing - Wing parts

/controls - Control surfaces

/motor - Motor frame

/source - Project for FreeCAD

Recommended printer settings:

Layer height: 0.25mm

Nozzle : 0.4 - 0.5mm

Filament : PETG / PLA

Assembly recommendations:

Put receiver into battery tray.

Glue wing to fuselage, you really not need to remove wing for all lifetime.

Elevator lift should be 8-12mm by tail edge, not more, trust me.

If you have troubles with aft positioned COG, you may install spinner

Drill hole in motor frame for upper screw.

You may want to add a piece of tape on cover lock for better locking.

Flight recommendations:

Keep air speed! Low speed = spin stall = death :)

Keep away from sharp maneuvers using elevator, fly smooth.

https://www.youtube.com/watch?v=AyscjXv45IU

Print Settings

Rafts:

Doesn't Matter

Supports:

Resolution:

0.25

Infill:

Filament brand:

FDPlast

Filament material:

PETG / PLA

Lavochkin La-11 RC Plane