Stats using Creality Printer w/ Ender 3 v3 Plus, Creality Hyper PLA

Filament
- Model Total 266m
- Support (using directions below) 24m

Print Time
- 27 Hours

Process Settings - All Parts
- .20mm layers
- 2 Wall Loops
- 10% infill
- Gyroid infill pattern
- Supports (on everything EXCEPT the body)
-- Enabled
-- Tree(auto)
-- Tree Hybrid
-- On build plate only
-- Support critical regions only
-- Remove small overhangs

Body
- Do not use any supports on the body. The sting drop below each brick adds to the weathered look. You may have an occasional loop that needs to be trimmed.
- I do not have a multi-color printer so I have tried both manually swapping filament every 5 brick layers and slicing the model every 5 brick layers and printing one plate in brick red and one in gray marble. Both work.

Assembly Directions

- Glue window glass into window frames from behind

- Glue windows into window inserts

- Glue door into door insert

- Glue body to base - be sure to note the orientation of the door / windows

- Glue platform railing into platform - the bottom rail should be flush with the platform

- Glue the platform onto the lamp base (cone) by inserting the cone up though the platform

- Insert the lamp LED up through through the light base

- Tape the LED leads to the underside of the lamp base (cone) - do not glue the plug until you have tested the LED

- Feed the LED wires down through the body of the lighthouse

- Mount the switch, make your connections, test the LED

- Gather up the wires / battery and insert the battery door

- Glue the lamp base plug into the hole near the top of the light

- Glue the platform to the top of the body - be sure to note the orientation of the platform to the windows / door

- Glue the lamp window frame to the underside of the roof

- Insert the lamp glass into the window frame and glue the window frame to the platform

Source for pulsing lighthouse LED:
https://evandesigns.com/products/light-house-light-for-miniatures

Source for push button:
https://www.amazon.com/dp/B0C2GBN5MX

Source for 9V battery connection:
https://www.amazon.com/Chanzon-Battery-Connector-Leather-Housing/dp/B083QFMXXW

Lighthouse: Lost in Time

0.2mm layer, 2 walls, 10% infill