A magnetic glasses case that was originally designed for clip-on sunglasses, but can be adapted to full sunglasses or even just standard glasses.

⭐ Subscribe to my Patreon to access the parametrized design files, request custom dimensions, and obtain a commercial license for all my models!

https://www.patreon.com/cw/FunctionalModels

Sizes

Comes in three sizes by default. Medium is the size shown in the images.

- Small: Fits glasses 125mm wide, 40mm tall, 12mm deep

- Medium: Fits glasses 135mm wide, 45mm tall, 15mm deep

- Large: 165mm wide, 60mm tall, 20mm deep

Assembly

1. The case prints in three parts. The Case_Bottom, Case_Lid, and Pin. The pin just pops in the right side of the case like so.

2. Insert magnets into the 4 locations shown below. Be sure to orient them in the correct polarity. The magnets I used are 4.7mm diameter x 3.2mm thick.

3. [Optional] Use the provided DXF files to laser cut felt inserts for the case, and super glue them in place.

This is not for commercial use. Subscribe to my Patreon for the commercial license to all my models!

https://www.patreon.com/cw/FunctionalModels

Magnetic Sunglasses Case (many sizes available)

0.2mm layer, 2 walls, 15% infill