Old lamp, but with LED candle:

Candela LED 1,4":

LED Candle

This model involves the use of PVB material filament to imitate glass, this material has the characteristic of becoming very transparent, using isopropyl alcohol for chemical smoothing of the surfaces.

the model, as for real lamps, provides the possibility of inserting the glass into place by lifting the chimney, in the case of this model, it is guaranteed by an elastic mechanism, the spring must be inserted manually to the press paused at layer 1425, when restarting the press, make sure you have fully inserted the spring, avoid steps.

TIP AND TRICK:

1) once the PVB printing is finished, spray isopropyl alcohol on all the surfaces, the advice is to spray the inside first, make sure that all the surfaces are hit by the alcohol, rotate the model to homogenize the treatment, then wait for it to dry , approximately 1 hour, at this point also do the treatment outside.

2) in the separately printed parts there is also the chimney cap, you can glue this with cyanoacrylate glue

Layer 0.10 mm

3 loop walls

Slicer BambuStudio, Printer Ender3S1Pro

filament Sunlu PLA and PVB

Infill 10%, Nozzle Temperature 220° and Plate 70°

SUNLU FILAMENTS

http://urly.it/3107gh

SOSTIENIMI:

https://ko-fi.com/F1F01016IP