https://**********.com/en/models/2092421-snaplock-box-for-phase-10-and-six-phase-counters#profileId-2262028 is the source for the original phase 10 box

https://**********.com/en/models/2412283-phase-10-counters-in-english#profileId-2644940 is the source for the original phase counters.

All I've done is arranged them in a printer friendly configuration that's colored in appropriately and arranged to be printed by object saving filament waste and time in printing.

I've labled all the plates appropriately to define which settings to use and how to print. ie. use .2 nozzle settings and print by object.

I HIGHLY advise using a .2 nozzle for the counter plates, it would be easier to print all the phase counter lids on one plate, but when printing by object, with multiple objects, the prime tower is omitted and it causes quality issues in the small print. I arranged each phase counter lid on a plate of its own and enabled prime tower. I've uploaded the 3MF using my .2 nozzle settings printing with PETG as it is my preferred filament for generally everyting. You may need to fine tune the speeds and extrusions for PLA. Use general settings for everything else with a .4 nozzle such as the box lid, the card holder, box bottom, and the phase counter bottoms. The phase counter lids or plates with the small writing definitely need a .2 nozzle as I couldn't get the print to be legible using a .4 nozzle. All the photos you see here are of my own prints using these settings and everything came out wonderfully.

I prefer variably layer height for speed and quality, otherwise .2 layer height will suffice, no supports and 20% infill is generally enough.

If I can be of any help, please comment, message anything, I'll help as much as I can.

ENJOY!

Phase 10 box with phase counter

0.08mm layer, 3 walls, 20% infill