NO CSF, NO PROBLEM !! See how I did it!!

My uncle used to be a Star Wars fanatic growing up: Millenium Falcon measuring about 15-18", figurines, jet figther, you name it!

===> Found this right here on Creality by CrealityKid!!

The only thing I do not like about a few holder is the inhability to charge your phone while sitting on it! so I used OnShape to remove the front holder and placed two instead spread apart and build a hollow box to raise it from the table so the cord can fit.

I have uploaded the original, the I have three versions + the Original:

- The V1 is how I printed it to avoid as much supports as I could... used CA glue to put it back together!

-- Black for the raised box and the Plateform

-- Then I used Gold and did a pause after slicing it to change it to white after a few layers... Make sure to "re-slice it" after you add the pause... the put it together!

- V2 is black on the raised box, then 3 colors afterwards: black for the base, then 'pause', change to gold (silver would also look great but less color contrast), then another pause for white on the rest... make sure to set your Z at a good clearance to get the supports off more easily w/out damaging your model... I set mine at 0.285 !!! then for the XY clearance I did 0.4 !!

- V3 is just more supports since it's all in one block... you can still do all the color changes anyway

- Obviously the Original from CrealityKid w/out a box and the "pin" up front for holding your phone up! ENJOY and thanks Creality Kid for the Great Design !!!!

Phone Holder_Star Wars Storm Trooper_Remix