This RPM Patreon "Tree" model is made by Jacob Olsson.

It is well detailed sweet model of tree. I have printed its stl file model on scale 100%. The Model required tree support. I have added Tree Manual Organic support at overhang portion only. Model will perfectly comes Out at any size with this setting. Carefully remove the support. It may break bunch of leaves. because it has low surface contact in 100% scale. for 200% may be it will not happen.

I have used the PLA Material.

Material Used: PLA+ White

Print Parameters:

1) Slicer Software : Creality Print 6.0

2) Printer: Ender3 KE.

3) Profile mode: Normal Quality (0.2mm)

4) Infill: 15% (Rectilinear Pattern)

4) Scale: 100%

5) Retraction: 2mm minimum.

6) Print Speed: 300mm/s.

7) Printing Temp: 220 0 c.

8) Bed Adhesion: Auto.

9) Support: Tree Manual (Organic)-at Overhang Portion only.

Note: Before printing Make sure Bed is well adhered with glued for perfect first layer.

I didn't find any issue with print. Go ahead with KE.

Hope You like it..!! Thanks for Watching..!! Happy Printing.

RPM Patreon "Дерево"

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill