Say goodbye to soggy, smelly sponges. This upgraded drip tray features a functional wave pattern that lifts your sponge (or soap bar) up, allowing air to circulate underneath and water to flow away freely.

🚀 What's New in V2?

Steeper Drainage Angle: The bottom slope is slightly increased, ensuring water flows down into the sink much faster without pooling.

Taller Wave Ribs: The ridges are now higher, which means even soaking wet sponges are kept well above the water line for maximum airflow and faster drying.

Key Design Feature: The front of the holder has a dedicated drainage spout/opening. Position this edge over your sink, and excess water will naturally drain out, keeping your countertop dry and your sponge hygienic.

The Set Includes 2 Sizes:

Standard (95x65mm): Perfect for standard kitchen sponges. Fits items up to ~95x65mm comfortably.

Large (115x85mm): Great for larger scouring pads or big bars of artisanal soap. Fits items up to ~115x85mm.

Printing Instructions:

Material: PETG or ASA are recommended because they handle moisture and cleaning chemicals better than PLA (though PLA works fine for a while).

Supports: None required.

Infill: 15-20%.

Watertight: Ensure your "Flow" is calibrated or increase wall count to 3-4 to ensure the tray doesn't leak.

Self-Draining Sponge Holder V2 | Wave Drip Tray

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill