Hanger dividers for Closet Maid single rod style closet organizers with sockets for interchangeable Cullenect labels. Keeps hangers separate to categorize clothing.

Files are included for left-handed dividers, right-handed dividers, left-handed labels, and right-handed labels.

Left-handed = hanger dividers & labels meant to be placed on the left side of the closet with text reading from top to bottom.

Right-handed = hanger dividers & labels meant to be placed on the right side of the closet with text reading from top to bottom.

Labels:

- If you're not picky about the orientation of the text, the Cullenect labels can be generated using @PerplexingLabs gridfinity/Cullenect label generator. (https://gridfinity.perplexinglabs.com/pr/cullenect-label/0/0). *Note that this will only generate labels where the text reads from top to bottom (i.e., right-handed) - thus, the text will be flipped (text reading bottom to top) if you use these with the left-handed divider.

File list:

- Creality project files with printer/process settings:

"wire_shelf_divider_with_label_socket_left.3mf"

"wire_shelf_divider_with_label_socket_right.3mf"

"wire_shelf_divider_label_blank_left.3mf"

"wire_shelf_divider_label_blank_right.3mf"

- STL files rendered via openscad files:

"wire_shelf_divider_with_label_socket_left.stl"

"wire_shelf_divider_with_label_socket_right.stl"

"wire_shelf_divider_label_blank_left.stl"

"wire_shelf_divider_label_blank_right.stl"

-See Cults3d for the openscad files and Gcode: https://cults3d.com/en/3d-model/home/single-rod-closet-hanger-divider-with-cullenect-labels

Adapted from:

- "Single rod closet wire shelving bracket (openscad)" by @konfuzed_203678 (https://www.**********.com/model/1174000-single-rod-closet-wire-shelving-bracket-openscad/collections), which was previously adapted from "Hanger Dividers for Closet Maid Wire "Shelf and Rod" by @louisblevine_274405 (https://www.**********.com/model/461880-hanger-dividers-for-closet-maid-wire-shelf-and-rod).

- Cullenect labels from Cullen J Webb: https://github.com/CullenJWebb/Cullenect-Labels

Printer/Process Settings for the hanger dividers:

- Filament: Creality Hyper PLA white

- Wall Generator: Arachne

Printer/Process Settings for the labels:

-Elephant Foot Compensation: 0.l mm (decrease/increase if the label is too loose/tight)

-Wall Generator: Arachne

*!Post-Processing Note!*

Definitely use a deburring tool followed by sanding to round out and smooth the openings of the "holes" - if you don't, then the rubber coating on the closet rods will get chewed up by the hanger dividers.

Single rod closet hanger divider with Cullenect labels

0.2mm layer, 2 walls, 15% infill