Wall mount designed for holding the Sonos Move 2 as well as charging base to allow charging and mounting of the speaker. Pass thru for wiring designed into the speaker.

Prints in 2 parts that are designed to easily and securely fit together for stable and sturdy mounting. This is designed to print on K1C print bed without supports.

Part 1 is the wall and hook feature that imagers into Sonos Move 2 handle recess to prevent tipping. Also features holes for screwing the part to the wall.

Part 2 is the charging base support. Designed to fit the standard charging base that comes with the move 2. Slots into the wall mount and sits on the rib supports that print in part 1. There is a tight clearance fit of the ribs onto the charging base, and the point of the ribs should recess slightly into the base.

I used zap-a-gap superglue to ensure a good bond between the two parts. This is highly recommended and the mount is unlikely to securely hold your Move 2 otherwise!

I printed both parts in PETG material with standard settings. Part 1 with the surface that touches the wall down, no supports and outer brim only. Part 2 printed bottom side down no supports, outer brim only.

After printing, assemble by applying a small amount of super glue to the part 2 charging base slots on all contact surfaces, then slotting the base onto the part 1 wall mount. Ensure the charging cord pass thru is fully lined up between both parts. Allow enough time for the superglue to fully cure before using.

For wall mounting I recommend using drywall anchors similar to the linked product below. #8 screws have a large clearance on the wall mount.

CONFAST 50 Pack Nylon Self-Drilling Drywall/Hollow-Wall Anchor Kit with Screws, (25 Anchors+25 Screws) Includes #8 Anchors with Screwshttps://a.co/d/2wfT2gK

Pacer Technology (Zap) Zap-A-Gap Adhesives, 1 oz, White (PT-02)https://a.co/d/cdmxfE7

Sonos Move 2 Charging Base Wall Mount

0.2mm layer, 2 walls, 15% infill