This is a heavily modified remix of the "Modular Table Clamp System - F360" located over on Printables at https://www.**********.com/model/631355-modular-table-clamp-system-f360. My remix version has been beefed up and changed for mounting Govee Outdoor Spot Lights, Camera systems, & more. Included is the .step file for the mounting plate model so you can modify this into anything that will lock into the extension arm or clamp body as your need requires.

This version was made for primarily clamping to horizontal home exterior wood trim pieces, in my case wood fake shutters. I added traction grip to the top jaw plus a small hook to the “beak” that lets it bite into the top of the wood and changed up the bottom jaw to a square design with traction added to let it bite into the bottom of the wood. I lengthened the clamp itself plus elongated the slots for the screw to pass through to allow the top and bottom jaws to clamp closer to the bottom of the clamp itself. Also added to the clamp body is 2 cable hooks on the side to help guide device cables in a more organized manner. In addition to this I beefed up the entire clamp so it can securely hold more weight without breakage especially in high winds and variable bad weather conditions.

With the changes to the clamp and lower jaw I also changed the clamp attachment piece to full new design for bolting on spot lights, cameras, and other objects. For my use I printed 4 of these systems and bolted on 4 Govee spot lights that I clamped to the front of my home, as shown in photos. I also designed an extension arm to help push the spot lights further from the home. The extension arm uses the same attachments so you can bolts the attachment plate directly to the clamp body or to the end of the extension arm which you attach to the clamp body depending on your needs.

I printed these for my own use in ASA with 50% Gyroid infill and 5 walls. The clamp body I print on it's back. The extension arm I print on the side. You can arrange the parts in whatever works best for you. If you do not need the extension arm do not print it. Really only the clamp body itself needs a high infill and the other parts could probably do fine at something like 25%-30% or so. I used organic tree supports.

Strong Modular Clamp System for Cameras, Floodlights, & More

Creality K2 Plus - 0.2mm layer, 5 walls, 50% infill

0.2mm layer, 2 walls, 15% infill