Training Cones – Low & High

🧩 Description

Two print-optimized training cones for football/soccer drills, agility work and marker courses:

LOW – wide, stable footprint; prints upright without supports; easy to stack.

HIGH – tall visual marker; supplied as two parts with a snap-fit joint (glue optional) for clean, support-free printing.

Both cones are open-top and designed to stack neatly. Surfaces show a clean 3D-printed texture.

🖨️ Printing Orientation & Tips

LOW cone

Print base-down (upright) – drafted walls enable support-free printing on common FFF printers.

Brim optional (use only if adhesion is weak).

HIGH cone

Print in two parts (upper + lower), both base-down.

Supports not required in this split configuration.

After printing, snap together until the joint clicks; glue is optional for heavy use.

🛠️ Recommended Settings

Layer height: 0.20 mm (0.16 mm for finer finish)

Walls / perimeters: 3–4

Infill: ≥ 20% (Gyroid) (increase to 30–40% if you want a heavier, more impact-resistant cone or plan to use it outdoors)

Top / Bottom: Bottom 4–6; top is open (stackable)

Supports: Not required in the provided orientations

Brim: Optional (for adhesion as needed)

Material: PETG (recommended) or other UV-resistant filament (e.g., ASA) for outdoor durability

Adhesion: PEI smooth or textured sheet with glue stick or another adhesion aid recommended

🧩 Assembly (HIGH cone)

Align the markers on the upper and lower parts.

Press firmly until the snap-fit engages all around the ring.

(Optional) Add a thin bead of CA glue inside the joint for permanent bonding.

⚠️ Notes & Safety

These are sports markers only — not load-bearing or safety devices.

Use responsibly. For outdoor use, prefer UV-resistant materials and avoid prolonged heat exposure.

☕ Support & Follow

If you like my designs, follow me — more functional everyday prints are coming soon, including tool organizers, workshop helpers, and printable accessories.

You can buy me a coffee simply by printing and boosting my files — nothing more 😉

Most of my uploads are completely free, so I’ll be truly happy if you decide to reward my work in any way.

If you’re interested in commercial use of this model, please contact me by leaving a comment.

Training cones, low and high

0.2mm layer, 2 walls, 15% infill