(Note: The original file names in the folders are in Turkish. "İstiflenebilir tabak - Kare" translates to "Stackable Bowl - Square Edition V2".)

This model is inspired by the unique jewelry box design found on Creality Cloud here:
https://www.crealitycloud.com/model-detail/unique-3d-jewelry-box?source=61&profileId=68edea863a70138cc39981d5

While the original design is beautiful, a user mentioned in the comments that the flat bottom made it difficult to stack securely. I have completely redesigned this from scratch (100% human-made CAD) to solve the stacking issue and create the ultimate interlocking version!

The Upgrade:
Instead of a flat base, I added a 45-degree chamfered recess at the bottom that perfectly matches the top rim. When you stack these bowls, they interlock seamlessly and will not slide off each other.

Check Out Other Versions!
This is part of an expanding collection! Be sure to check out my profile for the other shapes in this series:

Round Edition (V1)
Square Edition (V2) - Current model
Floral Edition (V3) - (5-Petal Flower)

Size & Scaling:

Dimensions: 101.98 mm x 101.98 mm x 31.93 mm.
I designed this at the minimum possible size for optimal utility. I highly advise against scaling it down.
Scaling Up: You can freely scale this model up! It will work even better. The recommended print settings below will remain completely sufficient and keep the model very sturdy, even at much larger sizes.

Tolerances & Files Included:
The standard tested version has a 0.15 mm tolerance. I printed this in PETG, and the fit is absolutely flawless. Since it prints perfectly in PETG, you will have zero issues with PLA.
I have also included 0.10 mm and 0.20 mm tolerance versions. All files are available in STL, STEP, and 3MF formats so you can print immediately or adjust as needed.

Print Time & Filament Usage:

Single Bowl: Approximately 3 hours 7 minutes | ~49.35g of filament.
Set of 3 Bowls: Approximately 9 hours 21 minutes | ~148.05g of filament.
(Note: Times may vary slightly depending on your printer and speed settings. Tested on Creality K1C).

Recommended Print Settings:
Due to the small default size and the wall count, the default print is practically solid.

Layer Height: 0.20 mm
Wall Loops: 3
Top/Bottom Layers: 5
Infill Density: 3% (Gyroid) - This is perfectly sufficient to maintain structural integrity even if you scale the model up!
Supports: No

If you've enjoyed my work and would like to buy me a coffee to support my creative efforts, you can do so through the link below. Your generosity is greatly appreciated!
Buy Me a Coffee: https://www.buymeacoffee.com/ahmetutkuozkan

Ultimate Stackable Ribbed Organizer Bowl - V2

0.2mm layer, 3 walls, 3% infill