Hueforge of an advertising poster for Underwold 3 - Rise of the Lycans

The photos shows the result in 200*150 and a nozzle of 0.4

You can change the X and Y dimensions but do not change the Z dimensions

You must define the printing parameters indicated in the description below and change the filament on the indicated layers.

You can use filaments other than those indicated, but the result will differ.

You can use any black PLA

Hueforge description

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150.04x200mm in size

You may print at higher layer heights below the Min Depth of 0.48mm

The Max Depth is 2.2mm and the Actual Depth is 1.6mm

Filaments Used:

PLA Forshape Black Transmission Distance: 0.2

PLA Sunlu Blue Transmission Distance: 4.1

PLA BambuLab Matte Ice Blue Transmission Distance: 3.5

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA BambuLab Basic Jade White Transmission Distance: 5

This print uses 5 unique filaments

Swap Instructions:

Start with Black

At layer #7 (0.64mm) swap to Blue

At layer #10 (0.88mm) swap to Ice Blue

At layer #12 (1.04mm) swap to Blue Gray

At layer #15 (1.28mm) swap to Jade White for the rest.

Underwold 3 poster - hueforge