This is the V2 Version of the Soundbar TV-stand clamp. This version makes the soundbar sit a little lower, so just in case your TV's bottom edge is very close to the TV stand, the soundbar sitting on this will not block your view. The V1 can be downloaded here if you want it:

https://www.crealitycloud.com/model-detail/683b4106d9bc4f366d1e9e6d?source=22

v2.1:

Adjusted the screw to be less... painful to screw on to the clamp. Also, for those really annoying screws, i made a screwing tool. Yes I know, i could have just added a hole to the top to make the screw screwable with a screwdriver, but I said screw it, I'll make it myself. Now you can screw with confidence. Just don't be too confident. The screw will break. Ask how I know.

Design Concept

Do you have a big TV with an even bigger TV-stand? Yeah, so do I. That's why I made this extension to the TV-stand, so that I can have my soundbar not-on-the-ground. This should not interfere with your TV image (unless you sit right under the TV on the floor).

My soundbar is a bit smaller in depth than 95 mm, but I made the mounting area 95 mm, so maybe someone with some cm extra thickness can use it too.

The screw is a slightly scaled down M22.

NOTE: The tolerance on the screw might be okay for you, however if you need to scale it, ONLY scale x and y-directions, don't scale z-direction! (if you want the screw to screw on to the screw threads! (screw))

This 3D model is designed to securely mount a soundbar beneath a TV on an Ikea TV stand, using an adjustable clamp system. The model integrates seamlessly with typical TV stand designs for a neat and clean look. Adjustable to any TV-Stand for thicknesses about 10 to 45 mm. (my tv stand is Ikea BESTÅ)

Use

It's intended for households seeking to optimize their home theater setup by securely mounting the soundbar in line with their TV, (hopefully) enhancing the audio experience (at least visual experience) without requiring additional floor or surface space.

Printing Suggestions

Use the material of your choice. Recommended print settings include a 15% infill and layer height of 0.2mm.

Assembly Instructions

After printing the clamp body and screw, just put the clamp on your TV-stand, screw on the screw and tighten. Use at least two clamps, one would need to balance the long bar alone, not ideal.

Thank you for all the support! If you like this model, check out the other designs I’ve created on my profile.

You can also buy me a virtual coffee to help fuel my filament addiction: buymeacoffee.com/ApuPrints.

Find all my socials here: linktr.ee/apuprintsolutions

V2.1 Soundbar Ikea TV-Stand mount with an adjustable clamp

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill