Design Concept

This wonderful jewelry box is a remix of the project by Barika, a young designer.

Compared to the original, I doubled the size and added an elegant embossed writing on the lid, precisely Parure which in French means matching of jewelry.

You can change the writing on the lid as you like because it is a separate text object that you can edit on your slicer.

Usages

It can be used to store jewelry or small personal objects, adapting perfectly as a furnishing accessory.

Print Recommendations

Doubling the size created big problems in printing the lid, because the supports of the original project are not adequate, and at a certain point the piece would come off the plate, or the supports would weld to the piece. I therefore had to do dozens of tests before finding the perfect profile for the supports suitable for the new dimensions. It is very important to let the piece cool completely before detaching the supports, and I recommend detaching them very delicately, so that they do not break.

I also had to add two modifiers: the lower one is used to slow down the printing a lot in a very delicate point.

The upper one is used to optimize the printing of the complex rounded surface of the lid that otherwise would have come out with very visible layers

Furthermore, the doubling of the dimensions forced me to heavily optimize the entire profile to find a good balance between quality and printing time.

Printing parameters

Both the lid and the statola were printed with Polymaker's PLA Polyterra, color Sakura Pink.

The printing temperature is 205 degrees, and that of the bed 50 degrees, layer height 0.2 and internal wall 0.5, material and lateral fans at 100%

Assembly instructions

The box is a single piece. It does not require further assembly after printing.

Let me know if improvements can be made

Wonderful jewelry box with customizable writing

0.2mm layer, 2 walls, 15% infill