My other designs aimed at aiding in Type One Diabetes Management



This design has been a long time coming!

I have designed smaller sharp containers in the past but this is by far my most ambitious design and print.

Be warned, this container is BIG.

The top section of the container has built-in support structures to assist with print bridging.

You do not need to add internal support but please print the test model first.

This will allow you to check you printer and slice settings to ensure your printer does not fail when it gets to the top section.

Test Model with built-in support:

Sliced with Creality Print 6.

You will notice that during the start of the top-section bridging there might be some stringing and section failing to bridge properly.

The subsequent layers will build onto and cover the initial failures to provided a smooth top finish at the end.

You will need more than 3/4 of a 1kg roll of filament to complete this print!

Print parameters:

Layer Hight: 0.2mm

Top & Bottom Layers: 6 / 1.2mm

Wall Loops: 3

Infil: 15-20%

Container Print Time: 2days and 9 hours

Filament length required: 262m

Weight: 780g

This is the 3d in my range of sharps containers.

XL Sharps Container