Best material:

Resin (ABS-like or High Detail resin) strongly recommended for capturing the fine braided texture and smooth inner band finish.

PLA+ works well for FDM when using silk, dual-color, or gradient filament to enhance the woven visual effect.

Layer height:

FDM (Creality K1C): 0.12 mm for sharp strand definition

0.08 mm for maximum surface refinement

Resin: 0.03–0.05 mm for premium jewelry-quality finish

Supports:

Yes, required.

The interlaced over-under braid pattern creates multiple overhangs exceeding 45°.

FDM: Use tree supports, touching build plate only, low density (10%).

Resin: Light supports under the lowest braid intersections and inside lower curve transitions.

Infill:

100% for wearable strength

20–25% if scaled as decorative object

Walls:

Minimum 4 perimeters to preserve strand strength and reduce seam visibility.

Orientation:

Tilt 30–45° backward to minimize support marks on the most visible braided surfaces and improve resin drainage if applicable.

Avoid printing perfectly vertical due to internal crossing geometry.

Scale Suggestions:

18–22 mm inner diameter → wearable ring

50–70 mm → artistic desk sculpture

90 mm → modern display piece

Aqua Nexus Weave Ring – Noah0x03