Needed a side mount for my Blink camera to put on my Ender 3 V3 Plus printer bed... I already had those cameras on hand, did not want to spend additional money for a new one. Light and small foot print, ideal not to take too much room.

Found Original version at https://www.printabxxx.com/model/1114235-blink-mini-camera-mount-for-ender-3-v3-plus/files by PanzerBus @PanzerBus_2631253

--> Original --> for V2 and V3 I made the camera nice and snug on the rack since it was too loose and wanted to add

--> V2 Model is the same as the Original Plus + Creality Logo (or not there is both) + tighter ring so my camera does not fall off

--> V3 I only changed the orientation so instead of sticking out backwards, I only kept the mount to the frame and redesigned the loop along the build plate so the camera is not so far out.

--> I uploaded the print with the Logo Attached to it to print in one shot or, also, separate so if you do not have a CSF you can use some CA glue to glue it on after printing them separated... (even if I have a CSF, I don't like to waste filament so I glued mine on but left you the choice! )

I printed my Ender accessories with PETG while Ender from Creality.

Did a 3 walls because of the screw mounts at 0.3/0.4 (yep! try the 0.3 high instead of 0.2... can save on printing time!!!). Infill 15% cubic just to give it more strength but quick print! Enjoy! ; )

Blink Camera Mount Ender 3 V3 Plus

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill