Celtic Toilet Brush Holder with Optional Roses for Eyes

Design Concept

Created a functional toilet brush holder with a skull and Celtic design.

This will fit most toilet brushes, however I added 3 STLs in case you need one smaller or larger

The one I printed was the 83mm, which is the 3mf. Fits a toilet brush from the Dollar Tree perfectly.

If your brush is over 3.5in, I recommend the 90mm design.

If your brush is under or right at 3 in, I recommend the 78.5mm design

Print Settings

K2 Pro 5hr 9min for the toilet brush holder and 10min for the roses

Toilet brush was printed using a .6 nozzle, .3 layer height, 3 walls, 10% infill.

Supports - tree hybrid on critical areas only. No brim

Roses - .6 nozzle, .24 layer height, 2 walls, 15% infill and no supports or brim needed

I printed on 2 plates, but added 3mf to print on one plate by object.

If you have a .4 nozzle, you may download the STLs

Also, if you like to use PLA then you may need to download the STLs as I used PETG

Assembly

If you print the roses, you just need to glue them into the eyes of the toilet brush holder.

Celtic skull toilet brush holder with optional eye roses