Let your party enter their next dungeon with grandure, using this dungeon gateway.

With its swappable gates, you can switch between:

Open metal gate

Closed metal gate

Full metal gate

Wooden door

There are two options: with and without sidewalls. When using this gate as an entrance, using the wall-version can be easyer to build with.

The gate-inserts are the same for each entrance.

The model does need support at the top arch part (hence the supportblock on the bottom). It does print without the support, but not very pretty.

Instructions:

Print the tiles of your choice.

Remove the small supporting pins on the sides.

Print Openlock clips to connect the tiles.

Push one or more Openlock clips into the tiles (depending on the size of the tile 1 can be enough, 2 works best with big tiles).

Connect the tiles together.

With the Openlock triplex base you can click the tiles together in a limitless configuration of your choice.

I added aditional beams, because I found that printing the big ones without them gives a very bad texture at the bottom. And if I put the time and money in tiles, I want them to be pretty and sturdy.

Dungeon tiles - gatehouse (functional)

Gatehouse without walls

Gatehouse with walls

0.2mm layer, 2 walls, 15% infill

Origineel