This is my first design I have modelled using AutoCad Fusion 360 and 3d printed using the Creality K1C printer that I was given as a Christmas gift from my family.

The print is a minimalistic style wallet that comfortably holds up to 10 credit cards along with a money clip to hold notes.

I have added an Apple AirTag housing on the case as I am always loosing my wallet - I have tested and it works well.

I started printing full PLA test models and then for the final version that I am currently using I used Creality Hyper PLA-CF filament for the outer housing and money clip and Creality CR PET-G for the inside parts. These are then sandwiched together using the M3x6mm bolts as well as flat elastic to keep the cards in.

Assembly instructions:

Along with the print you will need the following materials to put the wallet together:

- 14x M3 x 6mm Round Head Bolts (Or similiar). This is what the model is based on, and I have included M3 threads for the bolts within the inside parts.

- 400mm of flat elastic material 22-25mm wide. (you will need to sew this together as shown in the photographs.)

Steps:

1. Print Front and Rear Faces and Money Clip using desired material (suggest relatively high infill percentage 30~40% given the thin width of the part (2mm)

2. Print Inside Parts using desired material, again I went with 30% infill as there are also some thin sections once to allow suffient room for the elastic to be sandwiched together.

3. Once you have printed your parts test that the bolts thread into the inside parts sufficiently. Mine worked first go from the Creality K1C printer with no post-production required - very satisfying. Then leave just 1 bolt in each side so that you can put in the elastic.

4. If you are using the Apple AirTag you can put this in the housing before screwing the parts together. This will make it easier to remove if needed. It clips in easily - but is a snug fit and more difficult to remove once it is in place.

5. Sew the elastic together into 3 different loops. 2 of these loops connect the front and rear parts together and the third loop is used for the money clip. I have upload led more detailed steps on this if anyone needs.

6. Insert the elastic into 1 side then the other and then bolt each part fully together. Then clip on the money clip.

Enjoy!

Minimalistic Credit Card Wallet w Money Clip & AirTag Holder

0.2mm layer, 2 walls, 30 infill

0.2mm layer, 2 walls, 15% infill