🎉 Vote for me! 🎉 for the Annual Designer Awards 🎉



Please like, share, download, boost, rate and all the amazing good stuff!

Since this is my final model in my "Single Extruder - Dual Color" series where I managed to put 3 colors together into one model! Not counting the optional basket and cushion that would make it 5 colors.

The colors are mere suggestions, so I would like to see your space-cats, neon-cats and spooky glow in the dark cats! Just print every part in a different color and slide them together carefully.

The first time you slide them together they might be a little tight. If so, use a bit of PTFE/teflon spray. Also, slide them up and down, going lower bit by bit to ‘sand’ the rough edges and you will be able to take the model apart again. I have also added a hole in the bottom to create a central pressure point for disassembly if necessary. But as shown in the GIF, the cat could be completely friction free with the right printer and print settings.

Here are the previous designs in this series, the Dutch Cow and Burp the Derpy Frog:

Single Extruder - Dual Color - Dutch Cow

Single Extruder - Dual Color - Burp the Derpy Frog

And as always, if you like my models, don't forget to follow me!

Happy Printing :)

- Rossero

Single Extruder - Triple Color - Calico Cat

K2 Combo, 2 plates, sequential

0.2mm layer, 2 walls, 15% infill

Origineel