Who wants paint all over their hands? and who wants a handle that breaks mis-work??

Found in CritterNinja’s collection but the handle needed lots of support and then I had issues taking them off!

So I used OnShape to leveled the back of the handle so it could print properly w/out any support and still feel very comfortable!! I also removed the logo and there were a "knotch" in above the handle, I removed that too!)

I did not want to use he small dowel that came with the design so I used an M5 x 30mm screw with a washer + a lock washer (my screw is about ~5mm long but it allowed me not to struggle putting everything on... )

I used PETG, used a 0.6mm nozzle and did 0.3/0.6mm quality with:

- HANDLE: 3 walls (1.8mm walls) and top and bottom 5 layers (so 1.5mm thick). No support needed. Print it on it’s back so the weak lines are perfectly distributed to avoid to break apart!! I still did 25% cubic infill!! This handle is not going anywhere !!

- TRIGGER: I wanted the trigger hole very strong so upped the walls to 5 (most likely excessive!) 3mm/ and top and bottom at 4 layers for 1.2mm since my walls were so thick and 10% cubic at this point (walls extremely thick so did not see the use to do more)

4/2/26__ updated the trigger to make sure it depresses enough over the spray nozzle... now works with everything: my Killz, Rustoleum 2X, Krylon, Top Shield knob spray can... did not work so added an additional small square at the tip... works wonder! So I erased the old version that did not work for me which was most likely because I beefed up the handle to avoid any supports!

Cheers!

Strong Spray Paint Handle_No Support Needed

Origineel