Hueforge of a vintage Guinness advertising poster - Opening Time is Guinness Time (Toucan) by Gilroy (1936).

The photos shows the result in 150*200mm and a nozzle of 0.4

You can change the X and Y dimensions but do not change the Z dimensions

You must define the printing parameters indicated in the description below and change the filament on the indicated layers.

You can use filaments other than those indicated, but the result will differ.

You can use any black PLA

hueforge description

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150.01x200mm in size

You may print at higher layer heights below the Min Depth of 0.48mm

The Max Depth is 2.5mm and the Actual Depth is 2mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA BambuLab Basic Jade White Transmission Distance: 5

PLA BambuLab Basic Red Transmission Distance: 4

PLA BambuLab Basic Yellow Transmission Distance: 6

This print uses 5 unique filaments

Swap Instructions:

Start with Black

At layer #6 (0.56mm) swap to Blue Gray

At layer #7 (0.64mm) swap to Jade White

At layer #14 (1.2mm) swap to Red

At layer #19 (1.6mm) swap to Yellow for the rest.

Vintage Guinness advertising poster 01 - Hueforge