Ender 3 V3 Nebula Mount – Hybrid Remix

This remix was born out of necessity. I initially tried to combine two existing models for the Ender 3 V3:

https://www.**********.com/model/933835-ender-3-v3-corexz-cable-mount

https://www.**********.com/model/856745-ender-3-v3-z-axis-nebula-camera-mount

In addition to the primary functions of the original models, this remix also provides improved camera cable management, making it easier to route and organize cable for camera setups used in monitoring or time-lapse recording.

For mounting I used the original screws, the same ones used by the model for cable mount, but I added another model where M3x20 screws can be used if you think you need longer ones.

I decided that in my setup the filament goes from the top to the extruder. I fixed the sensor and its bracket to the top of the printer with this model:

https://www.crealitycloud.com/model-detail/6834d57faef686d178f9f6a6?source=26

I used this model to attach the cable:

https://www.**********.com/model/933835-ender-3-v3-corexz-cable-mount

After some time, I decided to fit some kind of camera mount into the whole setup, I chose this model:

https://www.**********.com/model/856745-ender-3-v3-z-axis-nebula-camera-mount

It was not possible to mount these two models on the printer together, so I combined Nebula camera mount and cable mount into a compact hybrid design.

Before starting to print the test model, I saw this model which gave me the idea that I should fit the camera cable better: https://www.**********.com/model/984397-ender-3-v3-z-axis-nebula-camera-mount

For mounting I used the original screws, the same ones used by the model for cable mount, but I added another model where M3x20 screws can be used if you think you need longer ones. To fix the cables to the mount, you will need 5 ties.

Ender 3 V3 Nebula Mount – Hybrid Remix

0.2mm layer, 4 walls, 25% infill

0.2mm layer, 2 walls, 15% infill

Oryginalny