Set the scene of your necromancer lair with these square pillars (filled with skulls ofcourse).

An easy supportless print to scare your party!

Instructions:

Print the tiles of your choice.

Remove the small supporting pins on the sides.

Print Openlock clips to connect the tiles.

Push one or more Openlock clips into the tiles (depending on the size of the tile 1 can be enough, 2 works best with big tiles).

Connect the tiles together.

I remixed the original tiles adding an Openlock triplex base you can click the tiles together in a limitless configuration of your choice. This way you can build the terrain easily and don't have to be scared the tiles get pushed around.

I added aditional beams, because I found that printing the big ones without them gives a very bad texture at the bottom. And if I put the time and money in tiles, I want them to be pretty and sturdy.

I also made the tiles bigger, and without a border to make the room more open.

I made the wall out of different pillars, and made them shorter because they were way to large, to save fillament.

Necropolis tile - square pillar

Square necropolis pillar on tile

0.2mm layer, 2 walls, 15% infill

Oryginalny