Boost Me

Encourage me to post more HO Scale and other model railroad content by boosting me,

Boost

There is a small bit of supports that can be removed very easily.

I would use a silk silver filament for those who don't want to paint. I used a silk silver PLA to print mine using an Ender 3 V3 KE with the attached settings.

In rev2 I used Hyper PLA white as I'm out of silver but will paint it. Rev2 fixes the ladder and adds A to the bottom metal area of the silo for easier identification.

ALL the components of the silo are modular so you can make it as tall as you want.

*The base file just print one component of each module.

*The Part with the A is the bottom part of the Silo (not including concrete platform) Only In Rev2

Note- ~~The ladder sometimes breaks if you speed up the print or using lesser quality filament. If it does just snip of the ladder as it looks good both with and without the ladder.~~ Fixed In Rev2 model.

If they don't easily connect with each other you can clip two corners of the square that lines it up. If clipping is required clip two opposite sides as not all filaments print the same(and printers).

HO Scale Grain Silo (1:87)

Grain Silo Rev2

Grain Silos

0.2mm layer, 2 walls, 15% infill