3d Printed Dragon artwork, Please follow the print instruction precisely (you can switch the colours up if you like, black isn't the best colour to see detail honestly. I will update the pictures on here eventually when i print in another set of colours./

Do not worry too much about transmission distances, this refers to how much light shines through x number of layers through y colour and brand of filament. I have left the information there for the Hueforge nerds. you can play fast and loose with the colours, so long as you don't mess too much with the other parameters you should get some great results.
The creation proccess involves taking created artwork into a lithography program, studying the transmission distances of various filaments to 'mix' colours and shades.

do not attempt to resize or thicken the design unless you know what you are doing, colour mixes are layer sensitive.

I'd love to see your prints.
Print instructions are as follows.

Project: DRAG.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 1.04mm

Filaments Used:
#080a0d PLA PolyLite Black Transmission Distance: 0.3
#a62f36 PLA+ IIID Max Red Transmission Distance: 4
#8c969d PLA+ Numakers Light Gray Transmission Distance: 0.1
#6e0b05 PLA+ Numakers Imperial Red Transmission Distance: 1.2
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Red
At layer #9 (0.8mm) swap to Light Gray
At layer #11 (0.96mm) swap to Imperial Red for the rest.

Black dragon 3d art