This is a fairly massive poop bucket for workbench metal leg magnetic attachment to sit under a poop chute. There is a small section in the back of the bucket that is open allowing for flush mount against a workbench leg that may have exposed bolts. I have the bucket mounted to the leg of my WORKPRO Adjustable Workbench and it sits perfectly flush around the exposed bolt heads of this workbench but the bucket would work great with pretty much any table or bench with metal legs.

I utilize 7 large 20x3mm magnets that are glued into the magnet pockets in the back of the bucket which offers extremely good holding strength even when the bucket is completely full of filament poop, print supports, etc. Do not try to use some cheap double sided tape to hold the magnets in place as it will not hold... I tried, lol. I added a small handle to the front of the bucket which lets me easily pull the bucket from the table and I often just sit it next to me as I remove print supports and toss them into the bucket and then snap the bucket back to my workbench.

If you so desire feel free to print multicolor and use the Color Painting (N) feature with height range painting and color the top section trim and lettering if you want a custom color accent. I did red for my print but the Creality green or any other color would look awesome as well.

I pair my poop bucket with the very nice "Creality K2 Plus Poop Chute Slide-overlength to trash can" model located at https://www.crealitycloud.com/model-detail/6816e150bf737a7e52df71e2 but this bucket should work for just about any setup as long as you have a place to magnetically attach the bucket (and you probably could even sit it on the floor if you desired).

Mega Magnetic Zilla Poop Bucket for Workbench Leg Mounting

k2plus 0.2mm layer, 3 walls, 20% infill