Microscope Stand Upgrade

This is small model to replace the microscope itself on microscope stand. Just today a new microscope arrived, which I plan to use in my work with a stencil printer. After all, the stand itself allows you to work without obstacles with a large offset.

I have a new good microscope, and by the way, to which there are also updates and you will see them with it a little later, but it has a table that does not allow you to move over large surfaces...

And a few words about the microscope for which this update: firstly, it works via Wi-Fi with iOS and Android, secondly, it is not expensive, thirdly its resolution is very worthy of HD, and also works from the built-in battery. Other descriptions and more can be found on the seller's page.

All parts except the microscope arm can be downloaded from the previous version. I inserted a 1 kg steel blank into the base, but if there is none, you can pour nuts, for example, and fill it with cement. Or figure out how to make it heavier yourself.

Microscope Stand Upgrade

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill