This 140+ card commander deck box is designed to be able to fit slabs from any major grading company or with the other insert can also fit standard sized mag cases. There is space next to the dice tray for 1 top loader in case you have a secondary commander that's not graded, as well if you remove the dice tray insert the box will hold over 25 top loaders.

The box also works reasonably well as a stand for scanning cards. If you place a blank sheet of paper under it and put your phone in the slab insert slot with the camera poking out over the edge it's just about the perfect position to scan, you may have to adjust height ever so slightly but I've been able to scan hundreds of cards very comfortably using this.

There are holes in both the Slab insert and the Mag Case insert as well as the box itself to accept 6mmx12mm barrel magnets glued in that way there is roughly a 1lb force holding the insert into the box. The tension insert will also need to be glued in on the registration pins that are modeled into the box, I always recommend fitting it into place first and checking that it's correctly aligned using one of the inserts to confirm and then gluing it in that orientation, it should work glued in either direction but I always lean towards being cautious.

This collection contains the models needed to print a SlabBox and all of the inserts, a deck box that I designed to fit a graded card as your commander. The models include:

SlabBox

Slab Insert

Mag Case Insert

Dice Tray Insert

Tension Insert

SlabBox V2.4