This is a 3D model of the instrument cluster bezel for the Ford Ranger. This is my design meant for the following parts :

Auto Meter Autogage Pedestal-Mount Tach 8,000 RPM - I used the littlest bit of glue to hold it in place, watch the depth too

GlowShift 52mm Oil Pressure Gauge - use mounting hardware

Glowshift 52mm Fuel Level Gauge - use mounting hardware

ScanGauge3 - use 3M Double Sided Tape provided

Compatible Years:

Ford Ranger: 1998–2011

Mazda B-Series: 1998–2010

(Note: Fits all Gen 3 interiors. For 2004–2011 models, remember that the cluster is tied to the PATS anti-theft system if you are doing a full swap).

Design Concept:

It includes all factory mounting points for a secure fit.

Print Settings:

I printed this successfully using PLA+ 2.0

Filament: SUNLU PLA+ 2.0

Nozzle Temp: 220°C

Bed Temp: 60°C

Layer Height: 0.2mm

Outer Wall 0.6mm

Inner Wall 0.6mm

Top Surface 0.6mm

Seam Gap 5%

Walls/Perimeters: 4

Infill: 10% Grid

Supports: Yes, Tree Supports

☀️ Pro-Tip: While PLA+ 2.0 is very strong, if you live in an extremely hot climate (100°F+ summers), consider painting the part with a UV-resistant clear coat or using ASA to prevent any softening during peak summer heat.

Feel free to adjust print settings as needed

2010 Ford Ranger Dash - MP3DP Design

0.2mm layer, 4 walls, 10% infill