This is a replacement remote casing for an Isuzu KB Pick-up (in South Africa we call it a bakkie). You need to remove the electronic circuit board, the batteries, the batteries plate and the screw from the old remote, to be used in the new remote.

Once printed, fill the hole on the lid (top) with hot glue. Stick tape on the outside and fill the hole from the inside. Remove tape access glue. Remove tape when glue is cold.

Please see Instruction Document for assembly instructions

Place the buttons into the top piece and the batteries plate into the bottom part as shown.

Place the Printed Circuit board (PCB) into the top. Make sure the stand-off on the top piece fits into the holes of the PCB. Fit the batteries into the bottom part. Make sure where the “+” is indicated, the flat part of the battery is on the top

Place the top onto the bottom, making sure the batteries do not move.

Screw the screw from the bottom, into the top

If does not work, make sure the batteries are the correct way installed.

Print Recommendation:

I printed mine with Fil X SBS filament.

Changes from standard settings
0.16mm layer
"Make Overhangs Printable" - Ticked
Wall Loops: 3
Bottom Shell layers: 5
Bottom Shell thickness: 2.2
Infill: 100%
Apply Gap fill: Top and Bottom only
"Slow down for curled perimeters" - Ticked
"Reduce infill retraction" - Un-ticked (clear)

Isuzu KB Remote (FOB) replacement case

0.16mm layer, 3 walls, 100% infill