Printed in Ender-PLA using a K1C. In this case, we will use the 0.20mm preset for the K1C. The print takes just 5 minutes to complete.

The following settings were changed in Creality Print from the default options.

Quality

Ironing type: All top surfaces

The way we are printing this will create the most visible surface of the print to need to be ironed so that it looks of a high quality.

Strength

Sparce infill pattern: Lightning

This print will not experience any loads of any kind, so all we have to worry about is that the roofs of the print are properly supported. To do this and save as much filament as possible, we use lightning for the infill pattern.

Speed

First layer: 30 mm/s

First layer infill: 50 mm/s

Initial layer travel speed: 50%

This is the number of top interface layers: 4

By reducing the initial layer (the first four layers to be precise) print speed, we ensure that the first layer adheres optimally to the print bed.

Other

Brim type: No-brim

There are no bed adhesion concerns with this print.

Брелок с ламой

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill