why?...

when using the lid riser which makes the bowden tube naturally bent and not pressed into the chain that feeds the cable to the head, I noticed that if we print on the left part of the table, the mentioned chain with the cable hits the left betweener which bends and causes a lot of noise, that's why I designed a slightly thicker version that fits the shape of the printer, is more stable and does not make noise, and what's more, it fits 2 other places on the betweener (apart from the back)

Print parameters

• Slicer software: orca slicer

• Printer: K1C

• Filament: generic-ABS 1.75

• Infill: i used 15-25%

• Nozzle Temp: 255°C

• Bed Temp: 100°C

but of course you can print any filament u want

INSTALLATION

If you don't know how to assemble a lid riser or you don't have one yet, check the attached link or JC lid riser

you just have to change betweener, it should work with every lid riser with 4 3x30mm screws

version without logo :

https://cults3d.com/en/3d-model/gadget/nologo-better-and-more-quiet-betweener-for-k1-k1c-lid-riser

better and more quiet Betweener for k1/k1c lid riser

Orijinal