Please Read This Before Starting your prints <3

In the download package there is several files, and they will give you the oppertunity to print 2 different versions, they are VERY similar, so please pay attention :D it's not hard, would just be a shame to print everything and then realising you don't need them all for the version you find best <3

There is 1 Candy bowl, there is just 1 and will be needed however you want to assemble it. (this can work alone if placed on a table, and can be adjusted to any size in that case)

Threads are a tight fit, and works best if screwed together and apart a few times, its ment to be tight, so the stand is as secure and possible.

Retro Tri-pod (bowl screw addon)

This part is used to glue to the bottom of the candy bowl, to be able to screw it onto the rod for the stand (DONT resize this unless you resize every part with threads to the same %, be carefull making it too small, or I can't guarantee the fit)

Retro Tri-Pod (Pole with Thread top+bottom)

This part is used to decide the height of your candy bowl stand (each of these will add 220mm to your stand, I used 2)

Retro Tri-Pod (Foot screw addon)

This part is used to glue to the foot, either version (unless you chose the version with threads on it already) this can help you fit the foot onto your buildplate, depending on how high you are able to print.

Retro Tri-Pod (Foot)

The tri-pod version of the foot, its without threads, so you will need to glue the "retro tri-pod (foot screw addon)" to it, center it and it looks great.

Retro Quad-Pod

This is the quad-pod version of the foot, it is less wobbly if you wanna go for a high stand, this version is without threads, so it needs the "retro tri-pod (foot screw addon)" aswell.

Retro Quad-Pod (with Screw)

This is the quad-pod version of the foot, this has the threads already on it, print this if you can fit it on your printer (remember to scale it accordingly if you changed any scaling on other files except for the candy bowl it self.

Retro Tri-Pod (Pole with Thread bottom)

Retro Tri-Pod (Pole with Thread top)

Use these files if you don't want the small addon parts, this will need to be glued on the corrosponding part to be able to screw everything together. In other words these are the "same" as the addon parts, but these are full rod lenghts (220mm)

Retro Quad-Pod Decor

This part if the decoration part, it adds foot-alike decorations along the stand, use how ever many you want, I used one just below the candy bowl. Gives the FULL print and nice finish and overall look.

Halloween Pumpkin Candy Bowl (with Stem)

This part has an inner-section with the stem on top, will have less room for candy, BUT looks more like a real carved pumpkin when waiting to be filled with delicious candy.

Halloween Pumpkin Candy Bowl (Lid)

Print this lid if you want your pumpkin to appear realistic when its waiting for you to take out some candy.

Halloween Pumpkin Candy Bowl with Stand and Decorations

0.2mm layer, 4 walls, 10% infill

0.2mm layer, 2 walls, 15% infill