The staff is about 1100 mm long and all the parts are cut in such a way that they can be printed by an Ender 3 (20x20x30)

It has 10.35 mm holes to be able to place 10 mm wood or aluminum rod as skeleton.

I recommend aluminum. With aluminum rods it is more resistant, but the final decision is up to you.

I usually print my parts with the following definitions ( Because I'm a cosplayer and I prefer to give extra resistance so that the prop resists well to the amount of convention people. You can change the settings if you want. ) :

Quality: 2.8

Walls: 3

Infill: 10% or 15%

Pattern: Zig Zag

- From my own experience, I give a margin of 0.30 mm to 0.35mm for the rods (wood or aluminum.), so that the rod can be placed and glued without the risk of them getting stuck inside the piece.

- I provide the full Staff not sliced and without holes, in case you want to slice in another way.

- Unfortunately, due to the Satff design, there are parts that will need support.

- I recently discovered a new feature in the program I use, so all parts were exported in high definition.

If you liked the model, please click on like and rate. It is very important for me to know that they like my models. If you have any suggestion or doubt, do not hesitate to ask. :)

You can whenever you need to send me a message here or on my Instagram. @Titi_Cosplay

Keyblade - Kingdom Hearts