This is the Valentine’s version. Check out my page for the other version. Both versions are fully compatible.

Package includes:
- Base
- Water tank
- Ground pin

Base dimensions:
- Outer diameter: 50 mm
- Inner diameter: 40 mm (10 mm wall thickness)
- Height: 185 mm (18.5 cm per base)

Printing note:
- Unlike the standard version, this base must be printed with supports.

- I made some mistake when creating the print settings. Turning the base by 180° will greatly reduce support waste!

Material recommendation:
Since the part will be in direct contact with moisture, it is recommended to use moisture-resistant filaments such as:
- PETG – good water resistance, durable, easy to print
- ASA – very good moisture and UV resistance, suitable for outdoor use
- ABS – moisture-resistant and mechanically strong (requires controlled printing conditions)
- ~~PLA~~ is not recommended, as it absorbs moisture over time, loses mechanical strength when wet, and can deform at relatively low temperatures.

Frequent switching of the modules on and off can reduce the clamping force. As they are intended to remain permanently attached, it is recommended to glue them in place as well.

Modular Mosspole [Valentines Edition]

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill