I wanted an adapter that could hold both sensor and could also support the Sprite Pro Harness on my Ender 3 S1. I didn't want to print separate mounts so I combined the two into one on Tinker Cad. S I found two mounts on Thingiverse by bamacups and twammons. I used tree supports. I added 3 layers, ironing, 30% gyroid infill. I had leftover Hyper PLA from my CFS and didn't want to waste it so I used it to create this multicolor mount on my Ender 3 S1.

Summary

Remixed to use M3 X 10mm Screws for mounting (Thicker mounting bracket 4.5mm). Also moved exit hole up slightly to line up with Stock Creality Runout Sensor from my Ender 3-Max. I have added a taller version (+20mm) to allow more room between the extruder and the sensor.

Print Settings

* Printer brand:Creality  

* Printer:Ender-3 Max  

* Rafts:No

* Supports:No

* Resolution:.28  

* Infill:50-700  

* Filament brand:IIIDMax  

* Filament color:Any  

* Filament material:PLA+  

Summary

This mount requires four M3 X 8mm bolts to replace the stock hot end mounting bolts on the Ender 3 Pro kit for the Sprite Pro. The holes for mounting the run out sensor will need to be tapped to M3. The holes behind the sensor are for zip ties. Put them into place prior to screwing the sensor into position.

Print Settings

* Printer brand:Creality  

* Printer:Ender-3 S1 Pro  

* Rafts:No

* Supports:No

* Filament brand:Inland  

* Filament color:Grey  

* Filament material:PETG+  

* Notes:I used PETG+ but regular PETG or PLA would work just fine as well.   

Summary

UPD: use ymount_2 instead of ymount. Original part was too close to extruder fan Print without support. I'm not sure if it will fits to s1, but on my s1 pro it mounts perfectly

fill free to remix of change as you want.

These parts do need any screws except that were with printer or sonicpad. No screwdriver needed for mount. Sot it is easy to install sensor without any tools. That was the main idea.

Print Settings

* Printer brand:Creality  

* Printer:Ender-3 S1 Pro  

* Rafts:Doesn't Matter

* Supports:No

Sprite Pro Sensors Adapted mount

0.2mm layer, 2 walls, 15% infill