This model is designed for Creality K1 printers.

The purpose of the design is to provide more effective filament drying by utilizing airflow and the build plate’s heat. (Ensuring proper airflow is very important — similar to how wet clothes dry faster when hung outside in the wind.)

I don’t have other printer models to test, so I can’t be completely sure, but I’m sharing the fan dimensions. You can compare them with your own printer — if the fan size is the same or smaller, you can safely use this design.

Fan dimensions: 118 mm x 12 mm

Note: The print has been tested and approved — it’s genuinely very practical and useful.

List of requirements:

A strong adhesive

Silica gel drying beads — you can use the ones that come with the filament since they’re free (optional) If you print the supports the way I set them, you won’t have any issues with the print.

When the printer reaches the pause layer I added, it will stop automatically — don’t panic! While it’s paused, you can place the silica gel through the hole in the middle.

3D printing settings

List of requirements:

A strong adhesive

Silica gel drying beads — you can use the ones that come with the filament since they’re free (optional) If you print the supports the way I set them, you won’t have any issues with the print.

When the printer reaches the pause layer I added, it will stop automatically — don’t panic! While it’s paused, you can place the silica gel through the hole in the middle. PLA-ASA-ABS

TORNADO FİLAMENT DRYER