This is a compact storage rack for the Dremel Flex Shaft attachment (available here: https://www.amazon.com/Dremel-225-01-Flex-Shaft-Attachment/dp/B0000302Y8/ ). It is compatible with pegboard (standard 1/4" holes with 1" spacing), but also includes holes for custom mounting solutions. It additionally features storage locations for a standard Dremel wrench, a few Dremel tools, and the unique chuck that comes with the Flex Shaft. **Instructions / notes:**

* Print out one "Dremel Flex Shaft Rack.stl". The rack is about 6" long. If it's two big for your printer, print out a "Dremel Flex Shaft Rack Right.stl" and a "Dremel Flex Shaft Rack Left.stl" and glue them together.

* If you want to store Dremel tools on the rack you might need to glue some small magnets ( 3mm diameter by 1.5mm thickness ) into the horizontal holes to add some holding force.

* If you want to pegboard mount the rack, print out two "Flex Shaft rack pegboard pin.stl" and glue them into any two of the 1/4" holes in the rack. Be careful to set the pins at the correct depth. For my pegboard the depth is about 10mm, leaving 5mm of pin sticking into the pegboard. Yours might be different. I recommend inserting a pin in your pegboard, marking a line for the depth, and then gluing to that line.

* If you are not using a pegboard, you can mount it as you like using the holes provided. The rack features four 1/4" holes and two M4 holes spaced as follows: * The M4 holes are 50mm apart. * The center 1/4" holes are 1" apart. * The outer 1/4" holes are 5" apart.

* You can design your own mounting bracket or use the simple right angle mounting bracket I've included ( "Simple angle bracket.stl" ). I've also included a bracket for mounting on an Ikea RÅSKOG Utility cart: http://www.ikea.com/us/en/catalog/products/20271892/ ( "Cart bracket.stl" ). It should also work on any 0.875" diameter shaft.

Dremel Flex Shaft Storage Rack (pegboard compatible) with ex

0.2mm layer, 2 walls, 15% infill