This external graphics card enclosure can be printed without supports. This eGPU enclosure can be used with oculink compatible laptops / mini PCs etc, and significantly boost graphics card and PC / laptop performance for gaming and various other workloads.

It can fit an SFX PSU (not an SFX-L PSU).

Fits graphics cards upto an absolute maximum of 230mm long, not including the metal bracket on the gpu in the measurement, or 241mm including the GPU metal bracket. The GPU can be up to 50mm thick, which is slightly wider than a two slot gpu.

You will need:

- an ADT F9G Oculink board which can be found from Aliexpress / Amazon / eBay.

- a 24 pin ATX extension cable (left orientated if you use the link below, but check with the store) - specifically like the one that can be found here and seen in the model pictures: https://www.aliexpress.com/item/1005009595066379.html?spm=a2g0o.order_list.order_list_main.11.56141802X59dcX

- You will need four M3 countersunk bolts approx 25mm long, and four washers and lock nuts to secure the ADT F9G Oculink board.

The ATX 24 pin extension helps slim down the wires that come out the side of the ADT F9G when you have connected the cable, allowing it to fit into the enclosure.

Once the board is secured with the bolts / nuts, nothing else needs tools. Simply put your GPU in place, and put the gpu securing tab in place. Put your SFX PSU in place, and connect it to the GPU's 8 pin or 6 pin power ports. Connect the PSU's 24pin to the 24 pin atx extension. There is a tab which can be used to cable tie cables together to keep them out of the way.

I have also added an option to potentially add a 90 / 92mm fan on the side of the case that the PSU is on. The fan would likely need to be powered from a 12v connector / adapter to a molex connector on the PSU or similar.

Please note that I have changed a couple of small elements to improve the design since taking the photographs which are in the model files uploaded.

Let me know how you get on with this - I'd love to see the builds! Thanks all

Oculink eGPU external graphics card enclosure

0.2mm layer, 3 walls, 25% infill

0.2mm layer, 4 walls, 30% infill

0.2mm layer, 2 walls, 15% infill